The choice of wood for clogs is very important
Apr 21, 2023
Leave a message
The choice of wood The choice is very important. You don't want to wear a pair of shoes that are full of cracks and holes. According to the size of the foot, leave a margin of one centimeter, because the clogs will be trimmed later. This is untreated oak.
Start grinding and grinding, all you need to do is sand the rough wood surface down. After grinding one, don't forget that there is another one. It is recommended that you do not use any electric tools (except for the electric drill that may be used later) when making this project, because this project cannot be done in five minutes, and you can't eat hot tofu in a hurry.
Critical Teeth A word of caution when you are about to make the teeth of your clogs. Slow-slow-come~ First of all, mark the position and height of the clog teeth at the position where the teeth need to be installed. There are no hard and fast rules, but I suggest that the height should not be less than four centimeters. It is more convenient to walk this way. Start marking this is the chisel, in the photo it's blocked by the wood and it looks good first slowly "sawing out" the clog teeth, then gouging the bottom view with the chisel, these areas need to be patched.
To round the corners and strengthen the teeth of the clogs, it is time to pick up the wooden file and try to round the corners as much as possible. Then sand it down again to give it a nice finish. Then smear it with resin essential oil. Once you're done, you'll need to reinforce the clog teeth a bit. First, two holes are drilled in each tooth, glue is poured in, a plug is hammered in, and the excess is cut off. Wait for the glue to set. While you wait, you can think about where the lace holes are. Drill them out. Round the corners. Oil, oil. This way the clog teeth will not break.

